Pool Pump Replacement Cost 2021
A pool pump replacement costs an average of $440, with prices ranging from $80-$800 in 2021. These price estimates do include the cost of labor, according to improvenet.com.
Pool Pump Replacement Cost
Owning a pool involves routine maintenance, comprising of repairing the pool liner, repairing the pool heater, and replacing the pool pump. Your pool pump is a vital component of the pool’s filtration system, and as time goes on, they wear out. On average, higher quality pool pumps should be replaced every 8 to twelve years. If you do it yourself it includes the cost of the replacement pool pump, which could run from $150 to $800 or more subject to the kind of pump. When you hire a professional, the cost includes the cost of labor, that is an added $80 to $200.
Signs You Need To Replace A Pump
There are five obvious signs to look for when it comes to pool pump repairs, listed above. Rumbling noises should be noticed right away. Excessively-vibrating pumps will create sometimes loud and consistent noises. The most common reason for the noise is a pump coming loose or dislodged. Get this issue fixed right away before it becomes a larger problem. The good news for pool owners is this issue won’t require a costly repair.
Grinding sounds can be confused as rumbling at first. But, there is a big difference between these various sounds. Grinding means your pump needs new bearings. Older bearings can lead to motor overheating. Bearings are typically cheap, but replacing them requires opening the pump. This is a task best left to the pool service professionals.
Even a well-maintained and routinely checked pump will wear out over time. These pool pumps can last between 8 to 12 years. However, many pool owners may notice failure at an earlier age. If your pump is getting up their in age, it’s time to start thinking about repairs and/or replacement.
Bubbles in your pool water may seem innocent, but this is not a good sign at all. Bubbles are a clear indication of an air leak in your pump. Dirty water can result from an air leak and can pose numerous health hazards. Have a pool cleaning service check this issue out immediately.
When Is It Time To Replace A Pool Pump?
There are two elements in pool pumps: the pump device and the motor device. Either one could fail and will need your attention. indicators that it’s time to replace your pool pump comprise of:
- Total motor failure
- Loud noises coming from the motor
- The pump isn’t pumping water, or the pump is leaking
Steps To Replacing A Pool Pump
Follow this guide if you plan to replace a pool pump for your next DIY project:
1. Turn Off All Power
The safest way to disconnect the power source to the pump is to switch the appropriate circuit breaker to the “off” position. Then, test the pool pump just to make sure the power is now off.
2. Disconnect And Remove The Pump
Once the power is completely off, remove the motor cover and disconnect the electrical wiring. Next, disconnect any plumbing connections to the old pool pump. Use an adjustable wrench to make the disconnecting process easier. Make sure you are being careful to not damage the connections since you will need them for the new pump installation. After it has been completely disconnected, it is safe to remove the pump entirely.
3. Connect The New Pump
Connect the electrical wires to the new pump after removing the motor cover. Once all electrical and plumbing components are connected, you can turn the pump on and begin priming it.
4. Turn On Power
Keep the power switch in the “off” position on the pump, then turn the appropriate circuit breaker to the “on” position.
5. Prime The New Pump
Fill the pump with water to make sure the pump trap fills properly. Once you turn the new pump on, carefully monitor the water to make sure it moves through the pump’s suction lines. Open the inlet shutoff valves until the water circulates throughout the pump. Your pump should be ready to go at this point.
Pool Pump Motor Replacement
If the pool pump is somewhat new (ten years old or less) and the exterior of the pump does not show indications of degradation, just replacing the motor could be a good idea. When the pump has some age to it, and the motor replacement parts are exhausting to track down or when the cost of the motor replacement is higher than 75% of the cost of a total pump replacement, total pump replacement is the route you should take. If the pump is still under its warranty, then totally replace the pump. Motor replacement is a lot less expensive than replacing the entire pool pump. Replacing the pump yourself costs somewhere between $25 to $200, whereas hiring a professional could cost an additional $40 to $100.
Pool Pump Replacement In Gilbert, AZ
Pool Service Gilbert is a family-owned and operated business that has been serving the valley since 2004. We offer reliable and affordable pool services, including repairs, replacement, equipment installations and more! Our service area includes Ahwatukee, Chandler, Gilbert, Mesa, Phoenix and Tempe, Arizona. Contact us right here for your upcoming pool service needs! Call us at 480-748-3022 for more information.